The Subaru had some rust in the corner of the wheel arch. There wasn't much left + the anoying fact that it won't stop eating my car! We had to fix it and my wish was not to use to much epoxy plaster.
Think we did a good job!
Cut all the rust away with the grinder! Testfit the new plate;
Extand the plate with a part of the wheel arch and the bottom part wich holds the bumper!
Since the sheet metal is quite thin it was hard to weld it without going through! Then the sanding starts!!
Protect the blanc metal with zinc spray and good old Owatrol on harder to reach places.
Then put on the epoxy primer and sand it down to a flat service. I used primer paint to protect it for now.
Whole car needs to be respayed due to scratches and different colored parts.
Like new !! :-)